GB
20
Wheels (4.00-8) with adjustable track
(35-40-45-50 cm)
These wheels have hexagonal axle holes and a hub
with two through holes.
To adjust track width, fit wheel (fig. 20/3, item 1) to
hub (4) by means of pin (2) at the through hole which
gives the desired width.
For wide track settings, use spacer (3) between hub
and wheel. Track can be further widened by about 5
cm by reversing the wheels (with the outside of the
rim on the inside).
In this case, however, you must switch the left and
right wheels over to keep wheel tread pointing in the
right direction.
Wheels (4.00-10) with adjustable track
These wheels have removable flanges and a hub with
three through holes. To adjust track, first fit flange (fig.
20/4, item 3) to wheel (1) with the four screws (4).
Then fit the wheel to the hub (6) and secure with pin
(2) at the holes giving the required track width (vari-
ous settings are possible). With wide track settings,
use spacer (5) between hub and wheel. Further ad-
justment can be obtained by reversing and switching
the wheels as instructed above.
MAINTENANCE
To ensure continuing reliability, use only original
spare parts when overhauling or repairing your two-
wheel tractor.
ENGINE
Make sure you do comply with the safety precautions
contained in the engine Operation and Maintenance
Manual.
During the first 50 hours (running in)
For the first 50 hours do not use the machine for
heavy duty work.
The following additional instructions must also be
complied with during the running in period.
DRY TYPE AIR FILTER (HONDA GX 200)
Every 8 working hour
Carefully clean the air filter cartridge with air com-
pressed and in case of any damage substitute with
new one
OIL BATH AIR FILTER
(HONDA L 70 LOMBARDINI 1 IM 359 /
15 LD 315 HONDA GX160)
Every 8 hours
Check the oil level in the air filter. If necessary, top up
with engine oil.
Clean the filter element as instructed in the engine
Operation and Maintenance Manual.
NOTE
Filter cleaning frequency depends on operating con-
ditions, but should never be more than 8 hours.
Every 60 hours
Clean the filter element, and change the filter oil as
instructed in the engine Operation and Maintenance
Manual.
GEARBOX AND TRANSMISSION
After the first 50 hours (running in)
Change the gear/transmission oil (see fig. 21).
Change the oil when the engine is hot to facilitate
draining of oil.
a.
Remove the left wheel.
b.
Remove the oil dip-stick (1).
c.
Remove the oil drain plug (2) from the bottom of
the gearbox (left side) and let the oil drain out.
When fully drained, reinstall the plug (2).
d.
Fill up with new oil (1.5 liters) of the following
types:
−
SAE 90 for ambient temperatures
between -6 and +32°C;
−
SAE 140 for ambient temperatures
b32 and +60°C.
