GB
19
COUPLING ATTACHMENTS TO
THE PTO
The PTO is fitted with an instant adaptor device to fit
attachments quickly and easily.
Proceed as follows to fit your attachments (see fig.
19):
a.
Check that lever (1) is in “disengaged” position.
b.
Push the shaft of the attachment (2) into the PTO
(3). Make sure that it engages fully.
c.
Lower lever (1) to the “engaged” position. Check
that the attachment is correctly locked.
WHEELS
TRACK ADJUSTMENT
Track width can be adjusted to suit the type of wheel
fitted.
Wheels (4.00-8) without adjustable rim
These wheels, that are fitted to the hub (fig. 20/1, item
1) by means of four studs (2) and the associated
nuts, can be installed in a single position only, there-
fore, track cannot be modified.
Wheels (4.00-10) with adjustable rim
This type of wheel is fastened to the hub (fig. 20/2,
item 1) by means of four studs (2) and the associated
nuts, and is provided with an adjustable rim.
Track adjustment is carried out by placing the flange
(3) either on the inside or the outside of the rim (4),
and securing it with the screws (5) and nuts (6) as re-
quired to suit the chosen rim width.
NOTE
Flange (3) can be positioned on the inside of the rim
with the protruding part pointing to either direction.
If the flange is installed on the outside of the rim, the
protruding portion can point to the
outside
only.
Three different adjustments of track are thus possible.
