15
H.264 Network Video Encoder
SECTION 2: INSTALLATION AND SETUP
To connect an RS-232C device wiring to the encoder:
1. Route wiring from the RS-232C device interface to the encoder.
2. Strip 1/4” of insulation from TX, RX, and GND wires from the device and insert them into the upper
terminal block RS-232C TX, RS-232C RX, and RS-232C GND pins, respectively, as shown in the
schematic above.
2.7.6 LAN, video, and power connections
1. Attach the network LAN cable to the RJ-45 connector on the encoder back panel.
2. Attach the video stream from your camera to the Vin BNC connector on the encoder.
3. If the encoder is not powered through the Ethernet (PoE), attach the DC12V adapter to the power
connector on the encoder and plug the power adapter into a power source.
LAN and power connections
CAUTION
Overvoltage and overcurrent will cause severe damage to the encoder.
2.8 Configure the encoder IP address
1. Open the directory where you installed the IPAdmin Tool. Double click the filename
IPAdminTool.exe
to start the application. When IPAdmin Tool starts, it will discover all of the
