1
INTRODUCTION
INTRODUCTION
The information contained in this manual will allow you
to operate and maintain your Rytec
®
Turbo-Seal
®
Door
in a manner which will ensure maximum life and trouble-
free operation.
Any unauthorized changes in procedure, or failure to fol-
low the steps as outlined in this manual, will automati-
cally void the warranty. Any changes in the working
parts, assemblies, or specifications as written that are
not authorized by Rytec Corporation, will also cancel
the warranty. The responsibility for the successful oper-
ation and performance of this door lies with the owner of
the door.
DO NOT OPERATE OR PERFORM MAINTENANCE
ON THIS DOOR UNTIL YOU READ AND UNDER-
STAND THE INSTRUCTIONS CONTAINED IN THIS
MANUAL.
If you have any questions, contact your Rytec represen-
tative or call the Rytec Technical Support Department at
800-628-1909. Always refer to the serial number of the
door when calling the representative or Technical Sup-
port. The serial number plate is located inside one of the
side columns.
The wiring connections and schematics in this manual
Rytec
System 4
Control
Panel
Left Side Column
A8500206
Head Assembly (Includes
Drive Motor Gearbox Assembly)
Right Side Column
Figure 1
are for general information purposes only. A wiring
schematic is provided with each individual door specifi-
cally covering the control panel and electrical compo-
nents of that door.
DOOR SERIAL NUMBER(S)
Your
DOOR SERIAL NUMBER
information can be
found in three universal locations. These are at the
inside of either side column (approximately eye level),
on the drive motor, and on the inside door of the System
4 control panel. (See Figure 1)
IMPORTANT: When installing multiple doors
of the same model but different
sizes, verify the serial number in
the control panel with the one in
the side column.
HOW TO USE MANUAL
Throughout this manual, the following key words are
used to alert the reader of potentially hazardous situa-
tions, or situations where additional information to suc-
cessfully perform the procedure is presented:
WARNING is used to indicate the potential
for personal injury, if the procedure is not
performed as described.
CAUTION is used to indicate the potential
for damage to the product or property
damage, if the procedure is not followed
as described.
IMPORTANT: IMPORTANT is used to relay
information CRITICAL to the
successful completion of the
procedure.
NOTE: NOTE is used to provide additional infor-
mation to aid in the performance of the
procedure or operation of the door, but not
necessarily safety related.