Page 29
WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other part may create a hazard or cause
product damage.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
It has been found that electric tools are subject to acceler-
ated wear and possible premature failure when they are
used on fiberglass boats, sports cars, wallboard, spackling
compounds, or plaster. The chips and grindings from these
materials are highly abrasive to electric tool parts such as
bearings, brushes, commutators, etc. Consequently, it is not
recommended that this tool be used for extended work on
any fiberglass material, wallboard, spackling compounds, or
plaster. During any use on these materials it is extremely
important that the tool is cleaned frequently by blowing with
an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool overheat-
ing, use an extension cord that is heavy enough to carry the
current the tool will draw.
A wire gage size (A.W.G.) of at least
14
is recommended for
an extension cord 25 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
WARNING:
Keep extension cords away from the cutting area and
position the cord so that it will not get caught on lumber,
tools, etc., during cutting operation. Failure to heed this
warning may result in serious personal injury.
MAINTENANCE
CAUTION:
Check extension cords before each use. If damaged,
replace immediately. Never use tool with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
WARNING:
To ensure safety and reliability, all repairs should be
performed by a qualified service technician at a Ryobi
Authorized Service Center
to avoid risk of personal injury.
