Ryobi TS1351, Operator'S Manual

Page: 13 / 30

Page 13
1
15 30
45
33.9
30
45
.5
31
.6
2
15
30 22.5
31.62
45
0
1
5
15 30
45
33.9
30
45
.5
31.
62
15
30 22.5
31.62
30
31.62 45
TABLE EXTENSIONS
See Figures 11, 12, and 13.
If you plan to use the stop block, slide the stop block on the
back arm of the desired table extension first.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base.
See Figures 12 and 13.
Adjust the extensions to the desired length.
Secure them in place by positioning a clamp bracket under
each table extension beneath the miter table. Orient each
clamp bracket as shown in figure 13.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom of
miter table, securing clamp bracket against table extension.
STOP BLOCK
See Figures 11 and 14.
The stop block is included with the table extensions and is
useful as a stop for making repetitive cuts to the same
length. It can be installed on either side of the saw base:
■
Slide the stop block on the back arm of either table
extension, then insert the table extensions into the saw
base.
■
Use the small wing screw to secure the stop block to the
table extensions.
■
Loosen the small wing screw and adjust the stop block
the desired distance from the blade for the cut to be
made. For accurate placement of the stop block, mea-
sure the distance from the teeth set on the blade to the
stop block.
■
Tighten wing screw securely.
■
Plug the saw in.
■
Make a test cut in scrap material and measure the
length of the workpiece.
■
Make any necessary adjustments.
WARNING:
Always make sure your miter saw is securely mounted to
a workbench or an appropriate workstand. Failure to do
so could result in an accident resulting in possible serious
personal injury.
Fig. 11
STOP BLOCK
SMALL
WING SCREW
TABLE
EXTENSION
Fig. 12
Fig. 13
Fig. 14
CLAMP
BRACKET SCREW
SAW VIEWED FROM BOTTOM
CLAMP
BRACKET
CLAMP
BRACKET
ASSEMBLED
TABLE
EXTENSION
BRACKET
SUPPORT
MITER
SAW BASE
MITER
SAW BASE
TABLE
EXTENSION
STOP
BLOCK
MITER
SAW BASE
ASSEMBLY