Page 27
LASER GUIDE
Make several practice cuts on different styles and thickness
of material.
Follow the directions below for using your Laser Guide.
Removing Your Mark:
Position the laser line near the left edge of your mark on the
work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on the
work surface in order to leave the mark.
After you have become familiar with using your Laser Guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
Fig. 40
3
4
5
5
3
0
0
1
55
11
5
33
0
3 3
0
31.6
31.6
22.5
22.5
22.
5
22
.5
22
.5
15
30
45
3
1
5
5
00
4
5
5
DAN
GER
KEEP
HAN
DS AW
AY
FROM
BLA
DE
BROKEN
RED LINE
MOUNTING THE LASER GUIDE
See Figure 39 .
Unplug your saw.
WARNING
:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
See "To Install Blade" in the adjustments section of this
owner's manual.
Make sure inner blade washer is in place before posi-
tioning saw blade on the spindle of your saw.
Note:
The laser guide replaces the outer blade washer.
Place the laser guide onto the spindle, aligning the
double "D" flats in the laser guide with the flats on the
spindle.
Position flat surface of laser guide against the blade.
Warning labels are visible when laser guide is mounted
properly.
Depress spindle lock button and secure laser guide using
only the special hex key bolt
provided.
Note:
The hex key bolt has left hand threads. Turn bolt
counterclockwise to tighten.
Using the hex key provided with your saw, tighten bolt
securely.
Remove the hex key and store it in a safe place for
future use.
Replace the lower blade guard and blade bolt cover.
Retighten phillips screw securing blade bolt cover.
Tighten screw securely.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
OPERATION
See Figure 40.
The laser guide will generate a red colored line on the work
surface when the saw blade is spinning. The red laser line
will appear as a broken line on the workpiece when the blade
assembly is in the uppermost position and the motor switch
is activated. This broken line will let you see your mark and
your laser guide line at the same time, and will assist you in
lining up your mark for more accurate cutting of the workpiece.
ALIGNMENT
Align the laser line and your mark with the blade at the
uppermost position. Once both lines are in alignment, do not
move the workpiece until after you have finished cutting.
As the blade assembly is lowered toward the workpiece, the
broken line will become solid.
Fig. 39
BLADE
LASER
GUIDE
HEX KEY
BOLT
5 mm HEX KEY
INNER BLADE
WASHER
SPINDLE
