5
SPECIFIC SAFETY RULES
NEVER
reach behind, under, or within three inches of the
blade and its cutting path with hands and fingers for any
reason.
NEVER
reach to pick up a workpiece, a piece of scrap,
or anything else that is in or near the cutting path of the
blade.
NEVER
move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade is
rotating. Any slip can result in contact with the blade
causing serious personal injury.
AVOID
AWKWARD OPERATIONS AND HAND
POSITIONS
where a sudden slip could cause your
hand to move into the blade.
ALWAYS
make sure you
have good balance.
NEVER
operate the miter saw
on the floor or in a crouched position.
NEVER
stand or have any part of the body in line with
the path of the saw blade.
ALWAYS
release the power switch and allow the saw blade
to stop rotating before raising it out of the workpiece.
DO NOT TURN THE MOTOR SWITCH ON AND OFF
RAPIDLY.
This could cause the saw blade to loosen
and could create a hazard. Should this ever occur,
stand clear and allow the saw blade to come to a
complete stop. Disconnect your saw from the power
supply and securely retighten the blade bolt.
IF ANY PART OF THIS MITER SAW IS MISSING
or
should break, bend, or fail in any way, or should any
electrical component fail to perform properly, shut off
the power switch, remove the miter saw plug from the
power source and have damaged, missing, or failed parts
replaced before resuming operation.
ALWAYS STAY ALERT!
Do not allow familiarity (gained
from frequent use of the saw) to cause a careless
mistake.
ALWAYS REMEMBER
that a careless frac-
tion of a second is sufficient to inflict severe injury.
IF THE POWER SUPPLY CORD IS DAMAGED,
it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
MAKE SURE THE WORK AREA HAS AMPLE LIGHTING
to see the work and that no obstructions will interfere with
safe operation
BEFORE
performing any work using the
saw.
ALWAYS TURN OFF THE SAW
before disconnecting it
to avoid accidental starting when reconnecting to power
supply.
NEVER
leave the saw unattended while connected
to a power source.
TURN OFF TOOL
and wait for saw blade to come to
a complete stop before moving workpiece or changing
settings.
THIS TOOL
should have the following markings:
a) Wear eye protection.
b) Keep hands out of path of saw blade.
c) Do not operate saw without guards in place.
d) Do not perform any operation freehand.
e) Never reach around saw blade.
f) Turn off tool and wait for saw blade to stop before
moving workpiece or changing settings.
g) Disconnect power (or unplug tool as applicable)
before changing blade or servicing.
h) No load speed.
ALWAYS
carry the tool only by the carrying handle.
AVOID
direct eye exposure when using the laser guide.
THIS SAW CAN TIP OVER
if the saw head is released
suddenly and the saw is not secured to a work sur-
face. ALWAYS secure this saw to a stable work sur-
face before any use to avoid serious personal injury.
SAVE THESE INSTRUCTIONS.
Refer to them
frequently and use to instruct other users. If you loan
someone this tool, loan them these instructions also.
Summary of Contents for TS1342
Page 29: ...29 NOTES...
