![background image](http://html.mh-extra.com/html/ryobi/sc165vs/sc165vs_operators-manual_1506632007.webp)
7
FEATURES
Input ..................................... 120 V~, AC Only, 60 Hz 1.2 A
No Load Speed ..............................550-1,650 r/min. (SPM)
PRODUCT SPECIFICATIONS
Throat ......................................................................... 16 in.
Blade Length ............................................ 5 in., pin or plain
SAWDUST EXHAUST
This feature allows you to attach any 1-1/4 in.
(32 mm)
vacuum hose for easy sawdust collection.
SAW TABLE WITH THROAT PLATE
Your scroll saw has an aluminum saw table with tilt control
for maximum accuracy. The throat plate, inserted in the saw
table, allows for blade clearance.
SWITCH AND SWITCH KEY
Your scroll saw has an easy access power switch. To lock
in the
OFF
position, remove the yellow switch key. Place
the key in a location inaccessible to children and others not
qualified to use the tool.
BEVEL LOCK KNOB
Allows you to tilt the table and lock it at the desired angle
up to 45°.
VARIABLE SPEED KNOB
Turn the knob to adjust the speed from the high speed
of approximately 1,650 r/min. (SPM) to the low speed of
approximately 550 r/min. (SPM).
KNOW YOUR SCROLL SAW
See Figure 3, page 15.
The safe use of this product requires an understanding of
the information on the product and in this operator’s manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
BEVEL SCALE
The bevel scale and indicator show you the degree the saw
table is tilted.
BLADE TENSION KNOB
Loosen or tighten the blade tension by turning the blade
tension knob.
DROP FOOT
This foot should always be lowered until it just rests on top
of the workpiece to prevent the workpiece from lifting, yet
not so much that the workpiece drags.
DROP FOOT LOCK KNOB
Allows you to raise or lower the drop foot and lock it in place.
SAWDUST BLOWER
Keeps the line of cut on the workpiece clean for more
accurate scroll cuts. For best results, always direct air flow
at the blade and the workpiece.