Page 15
0˚
ON/OFF KNOB WITH VARIABLE SPEED
See Figure 18.
Your scroll saw has an easy access On/Off knob with
variable speed.
■
Pull the knob out to turn ON the saw, and push the knob
in to turn OFF the saw.
Note: After saw is turned on, a hesitation before blade
movement is normal.
WARNING:
Never leave the saw unattended until the blade has come
to a complete stop to prevent serious personal injury.
This scroll saw is designed to cut wood, wood composition
products, plastic, and nonferrous metals (aluminum, brass,
copper).
GENERAL OPERATION
Please read and understand the following items concerning
your scroll saw before attempting to use the saw.
■
There is a learning curve for each person who wants to
use this saw. During that period of time it is expected that
some blades will break until you learn how to use and
adjust the saw.
■
Allow the saw to cut material by guiding the workpiece into
the blade as it moves. Do not force the work.
■
The blade teeth cut material only on the down stroke.
■
You must guide the workpiece into the blade slowly
because the teeth of the blade are very small and can only
remove material on the down stroke.
■
Scroll saw blades wear out and must be replaced fre-
quently for best cutting results. Scroll saw blades gener-
ally stay sharp for 1/2 hour to 2 hours of cutting, depend-
ing on type of material and speed of operation.
■
To get accurate cuts, be prepared to compensate for the
blade's tendency to follow the wood grain as you are
cutting wood.
■
In cutting wood, best results are achieved when cutting
wood less than one inch thick.
■
When cutting wood thicker than one inch, the user must
guide the workpiece very slowly into the blade and take
extra care not to bend or twist the blade while cutting.
■
When choosing a blade to use with your scroll saw,
consider the following carefully:
• Very fine, narrow blades should be used to scroll cut in
thin material 1/4 in. thick or less.
• Most blade packages state the size or thickness and
type of material which that blade is intended to cut.
Package should also state the radius, or size of curve,
which can be cut with that blade.
• Wider blades cannot cut curves as tight or small as
thinner blades.
■
Blades wear faster:
• When cutting plywood and other laminates.
• When cutting material thicker than 3/4 in.
• When cutting hardwood.
• When side pressure is applied to the blade.
■
By turning the knob, the variable speed control may be
adjusted from the high speed of approximately 1550 SPM
(Strokes Per Minute) to the low speed of approximately
400 SPM. Suggested speeds are identified under Choice
of Blade and Speed, page 17. Turn the On/Off knob to the
right or clockwise to increase strokes per minute and to
the left or counterclockwise to reduce the strokes per
minute.
OPERATION
ON/OFF KNOB
Fig. 18
LOCK
OFF POST
