![background image](http://html1.mh-extra.com/html/ryobi/ry80030/ry80030_operators-manual_1506072009.webp)
9
ASSEMBLY
UNPACKING
This product requires assembly.
n
Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
n
Remove and discard the clear cap securing the operator’s
manual bag to the pump breather tube.
n
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n
If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Pressure Washer
30 ft. High Pressure Hose
Spray Wand Assembly (upper)
Assist Handle Assembly
Spray Wand Extension (lower)
Quick-Connect Nozzle (5)
Nozzle Cleaning Tool
Resting Foot
Axle Assembly (2)
Wheel (2)
Washer (2)
Hardware Bag
4-Cycle Engine Oil (10W-30)
Operator’s Manual
Warranty Registration Card
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
Fig. 2
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
NOTE: Do not start the pressure washer until the engine has
been filled with oil and all hoses are connected. Running this
machine without oil will damage the engine while running it
without water will damage the high pressure pump.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
To
attach the wheels to the pressure washer base:
n
Locate the axle assembly; remove the hitch pin from the
axle.
n
Slip the axle into the wheel hole and l
ift the mach
ine
slightly.
n
Next, slide the washer onto the axle. Still lifting the ma-
chine, slide the axle/wheel/washer combination into the
wheel mounting hole in the machine base as shown in
figure 2.
n
Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
n
Repeat with the second wheel assembly.
HITCH
PIN
WASHER
AXLE
Summary of Contents for RY80030
Page 20: ...20 NOTES ...