Page 22 — English
BUCKING WITH A WEDGE
See Figure 25.
If the wood diameter is large enough for you to
insert a soft bucking wedge without touching the
chain, you should use the wedge to hold the cut
open to prevent pinching.
NOTE:
When bucking or felling with a wedge,
you may need to remove the SAFE-T-TIP™ anti-
kickback device to allow the bar to be drawn
through the cut. After you complete the cut, reinstall
the tip.
BUCKING LOGS UNDER STRESS
See Figure 26.
Make the first bucking cut 1/3 of the way through
the log and finish with a 2/3 cut on the opposite
side. As you cut the log, it will tend to bend. The
saw can become pinched or hung in the log if you
make the first cut deeper than 1/3 of the diameter
of the log.
Give special attention to logs under stress to
prevent the bar and chain from pinching.
OVERBUCKING
See Figure 27.
Begin on the top side of the log with the bottom
of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull
away from you.
UNDERBUCKING
See Figure 28.
Begin on the under side of the log with the top
of the saw against the log; exert light pressure
upward. During underbucking, the saw will tend
to push back at you. Be prepared for this reaction
and hold the saw firmly to maintain control.
OPERATION
OVERBUCKING
Fig. 27
LOAD
FINISHING CUT
1ST CUT 1/3 DIA
LOG SUPPORTED AT ONE END
LOG SUPPORTED AT BOTH ENDS
FINISHING CUT
1ST CUT 1/3 DIA
LOAD
Fig. 26
Fig. 28
UNDERBUCKING
WEDGE
Fig. 25
Summary of Contents for RY5018
Page 119: ...Page 39 English NOTES ...