Ryobi RY36BI1800A, Manual

Page: 6 / 24

6
Original Instructions
BATTERY PORT LED FUNCTIONS
LED indicator Battery pack
status
Red
LED
Green
LED
Description
Power Without
battery pack
Solid - Ready to charge the battery pack
Testing Hot battery
pack
Flashing - When the battery pack reaches cooled temperature, the
charger begins charge mode.
Cold battery
pack
Flashing - When the battery pack reaches warmed temperature, the
charger begins charge mode.
Error Error Flashing Flashing Battery pack or charger error
Deeply
discharged
Flashing - The charger conditions the battery pack until normal
voltage is reached, then begins charge mode.
■ Reinstall the battery pack. If the LED status repeats a second time, try charging a different
battery.
■ If a different battery charges normally, dispose of the defective pack (see the battery pack
manual for instructions).
■ If a different battery pack also indicates an error, replace the charger.
Charging Fast charging - Flashing The battery is charging.
Ready Battery full - Solid Charging is complete.
TROUBLESHOOTING
Problem Possible cause Solution
The product does not turn
on.
The battery pack is not charged. Recharge the battery pack.
The main power button was
released too quickly.
Press and hold the main power button for 2
seconds.
The AC receptacle does
not work.
The AC output is not active or the
AC power button was released
too quickly.
Press and hold the AC output button for 2 seconds.
The charger is connected. There is no power output (AC and USB) while the
product is charging. Disconnect the charger after
the battery packs are fully charged.
The connected device is
defective.
Try a different device.
The product is overloaded. Remove the loads and press the AC output button
to reset the power hub.
The product unexpectedly
turns off.
The battery pack temperature is
outside of the normal operating
range.
Make sure that the battery pack temperature is
between -20 °C and 49 °C.
The battery pack has low or no
charge.
Recharge the battery pack.
The battery packs are faulty. Have the product serviced by an authorised service
centre.
The charger does not work. The battery pack temperature
is outside of normal operating
range.
Make sure that the battery pack temperature is
between 0 °C and 45 °C.
The connection between the
battery pack and inverter is not
good.
Reinstall the battery pack. If problem persists, use
another battery pack.
The charger's voltage is outside
the normal range.
Use another charger.
The battery pack is defective. Use another battery pack.
If the problem persists after trying the above solutions, contact your nearest authorised service centre for assistance.