![background image](http://html1.mh-extra.com/html/ryobi/ry121850/ry121850_operators-manual_1507314012.webp)
10 — English
OPERATION
MODE CONTROL SELECTOR
See Figure 9.
Allows adjustments of the pressure and water flow to fit the
requirements of your cleaning job. Adjust the water flow from
0.2 to 0.7 GPM with a press of a button.
Press the button to change the setting.
The LED will toggle from low, to medium, to high, back
to low with each press of the button.
SELECTING THE RIGHT NOZZLE FOR THE
JOB
See Figure 10.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the
Nozzle Selection Guide
for more information.
Rotate the nozzle until the desired position is selected.
NOZZLE SELECTION GUIDE
TURBO
15˚
RINSE
RINSING WITH THE POWER CLEANER
See Figure 11.
Turn off the power cleaner and shut off the water supply.
Engage the lock out on the trigger by moving the lock-out
button to the locked position.
Rotate the 3-in-1 nozzle to the desired position of the
three nozzles.
Select the right nozzle for the job. See the chart shown
earlier in the manual to select the appropriate nozzle.
Start at the top of the area to be rinsed and work down,
overlapping the strokes.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked with hands free of the
lock-out button when not in use. Remove battery pack
when transporting or carrying the tool to avoid accidental
starting, which may result in serious injury.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
STARTING AND STOPPING THE POWER
CLEANER
See Figure 8.
DANGER:
Improper application of cleaning solution can result in
SEVERE INJURY or DEATH. Follow CDC and EPA guide-
lines for cleaning.
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
WARNING:
Hold the power cleaner securely with both hands. Expect
the power cleaner to move when the trigger is pulled due
to reaction forces. Failure to do so could cause loss of
control and injury to yourself and others.
NOTE: Never place or immerse the unit in standing water.
To start:
Connect the garden hose or submerge filtered end of
siphon hose into water source.
Install the battery pack.
Place the lock-out button in the unlocked position.
Squeeze and hold the trigger to operate.
Start with the nozzle 1–2 ft. away from the cleaning surface
and carefully approach the surface just until the desired
level of cleaning is achieved. If the spray is too close it can
damage the cleaning surface.
To stop:
Release the trigger to stop the flow of water through the
nozzle.
Place the lock-out button in the locked position.
Remove the battery pack.
Summary of Contents for RY121850
Page 36: ...NOTES NOTES NOTAS...
Page 37: ...NOTES NOTES NOTAS...