WARNING
The water pump together with associated pipework
operate under pressure. Do not disconnect water
pump or pipework until internal pressure has been
released. Failure to do this could result in personal
injury and damage to property.
2
WARNING
WARNING
WARNING
The pump is not suited to discharge salt water,
sewage, flammable, caustic or hazardous liquids.
Please observe the max. temperature of the liquids
to be discharged stated in the technical data.
Inside the pump, lubricants are used which may
contaminate the liquids being discharged in case
of any improper operation or damage of the device.
The lubricants used are biologically degradable and
nonhazardous to health.
During the entire process of installation, the device
must not be connected to the electrical mains. The
pump and the entire connection system have to be
protected from frost.
INTENDED USE
INSTALLATION
SYMBOLS DEFINITION ON THE PRODUCT
WARNING
Make sure the pump is disconnected from electric
power supply before performing maintenance
procedures.
MAINTENANCE
CLEANING THE PUMP HOUSING
Use a moist cloth to wipe down the pump housing.
Allow to dry thoroughly before storing in a dry location
that is protected from bad weather conditions.
■
Ensure all connections are leak free. Use the
included thread seal tape (12) (included with
RSSS1000 only) or a suitable sealant on the
connection thread.
■
When tightening threaded connections, please
do not apply excessive force which may cause
damage.
■
When laying the connection pipes, you should
make sure that the pump is not exposed to any
form of weight, vibration or tension. Moreover, the
connection lines must not contain any kinks.
■
Avoid inserting hands into the inlets/outlets of the
water pump while it is connected to power.
■
Before using the water pump, always inspect it
visually. Do not use the pump if it is cracked and/or
damaged.
■
The water pump has a built-in thermal protection
overload switch. The water pump stops if an
overload occurs. The motor restarts automatically
after it has cooled down.
■
The pump must not be used when people are in the
water.
■
Never work or perform maintenance on the pump
without first making sure it has been disconnected
from the mains power.
■
Pollution of the liquid could occur due to leakage of
lubricants.
Important:
Avoid inserting hands into the mouth of
the pump if it is connected to the mains. The electrical
connection must always be made in a dry area. Make
sure that electrical connections are protected from
inundations.
Protect the plug and the power cable from heat, oil or
sharp edges.
■
A distinctive feature of this pump is that it can
briefly operated (max. 4 min.) with liquids with a
temperature up to 95°C (see Technical data).
■
RYOBI Submersible dirty water pumps are highly
efficient electrical pumps for discharging clear or
dirty water containing solids up to the maximum size
specified in the technical details.
■
This pump is intended for discharging clear or dirty
water containing solids up to the maximum size
35mm
■
Typical applications for waste water submersible
pumps are: Emptying ponds, tanks, storage tanks,
and waste water pits, emergency drainage in the
event of flood etc. This product is intended for
household use only, not for extended continuous
operation.
