Ryobi RPW3200, Original Instructions Manual

Page: 15 / 44

13
For long range detergent application:
With the nozzle installed on the spray wand
and the engine shut off, rotate the spray
selector to the Soap Long Range setting.
For short range detergent application:
With the nozzle installed on the spray wand
and the engine shut off, rotate the spray
selector to the Soap Short Range setting.
Before shutting off the engine:
■ Place the 5-in-1 nozzle to the 40
o
outlet
position.
■ Flush for 1 - 2 minutes (spray clear water
through the spray wand).
■ Shut off the engine.
NOTE: Shutting off (O) the engine will not
relieve pressure in the system. Pull the trigger
to release the water pressure.
RINSING WITH THE HIGH PRESSURE
CLEANER
■ Turn off the high pressure cleaner and
shut off the water supply. Pull the trigger to
release water pressure.
■ Engage the lock out on the trigger handle
by pushing up on the lock out until it clicks
into the slot.
■ Rotate the spray selector on the 5-in-1
change-over nozzle to either the [40º],
[25º], or [0º] setting depending on the job.
Refer to the chart in Using the 5-in-1
change-over nozzle to determine which
setting is correct for your application.
■ When using these settings, test a small
area first to avoid surface damage.
■ Start at the top of the area to be rinsed and
work down, overlapping the strokes.
MOVING THE HIGH PRESSURE CLEANER
See page 28.
NOTE: Never lift or carry the product using
the handle and never place it in any position
other than upright on its wheels.
■ Turn the high pressure cleaner off and
ensure the fuel valve is closed.
■ Pull the handle up until the handle release
knob snaps into the locking position (if not
already up and locked). Ensure the lock is
secured in the frame hole before moving.
■ Tilt the product towards you until it balances
on the wheels then roll the product to the
desired location.