7
English (Original Instructions)
operate this tool until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
■
Loosen the knob on the coupler of the power head
shaft and remove the end cap from the attachment.
■
Push in the button located on the trimmer attachment
shaft. Align the button with the guide recess on the
power head coupler and slide the two shafts together.
■
Rotate the trimmer attachment shaft until the button
locks into the positioning hole.
NOTE:
If the button does not release completely in
the positioning hole, the shafts are not locked into
place. Slightly rotate from side to side until the button
is locked into place.
■
Tighten the knob securely.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
(See Fig. 2c)
■
Loosen the knob.
■
Push in the button and twist the shafts to remove and
separate the ends.
ATTACHING THE SHOULDER STRAP
(See Fig. 2d)
NOTE:
Always use the shoulder strap with your trimmer.
Follow these steps to attach the shoulder strap.
■
Connect the latch on the strap to the strap hanger.
■
Adjust the strap to a comfortable position.
NOTE:
To quickly release the product from the shoulder
strap, sharply pull the quick release tab.
INSTALLING THE PRO CUT II™ HEAD TO THE GRASS
TRIMMER
(See Fig. 2e)
■
Stop the engine.
■
Remove the installed string head.
■
Install the Pro Cut™ grass trimmer head on the drive
shaft until fully seated.
■
Install the spool retainer and turn counterclockwise
■
Install cutting line as described in the next section in
this manual
INSTALLING THE LINE IN THE PRO CUT II™ HEAD
■
Use monofilament line diameter 2.7 mm. Use original
manufacturers replacement line for best performance.
2.4 mm Line is not compatible with the Pro Cut head.
For the head to secure the line safely 2.7 mm line must
be used.
■
Stop the engine.
■
Remove old line by pulling it from the holes located on
the top of the line head.
■
Gather two of the pre-cut lengths of trimmer line
provided or cut two pieces of trimmer line (in 28 cm
lengths).
■
Insert the line into the load slots located on the sides
of the line head. Line should be pushed in until
approximately 2 cm protrudes from the holes on the
top of the line head.
■
Pull the lines from the exit hole until it reaches the
cut off blade on grass deflector before operating the
product.
OPERATION
FUELING AND REFUELING
HANDLING FUEL SAFELY
WARNING
Check for fuel leaks. If any are found, correct
them before using the product to prevent fire or
burn injury.
■
Always handle fuel with care, it is highly flammable.
■
Always refuel outdoors where there are no sparks and
flames. Do not inhale fuel vapors. Do not smoke.
■
Do not let petrol or lubricant come in contact with your
skin.
■
Keep petrol and lubricant away from the eyes. If petrol
or lubricant comes in contact with the eyes, wash
them immediately with clean water. If irritation is still
present, see a doctor immediately.
■
Clean up spilled petrol immediately.
■
Always transport and store fuel in a container approved
for petrol.
MIXING THE FUEL
(See Fig. 3)
■
The product is powered by a 2-stroke engine and
requires pre-mixing petrol and 2-stroke lubricant. Pre-
mix unleaded petrol and 2-stroke engine lubricant in a