6
English (Original Instructions)
46. String head housing
47. Latch
48. String head cover
49. Bump knob
50. Hex bolt
51. Spool
52. Spring
ASSEMBLY
UNPACKING
This product requires assembly.
■
Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
■
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
PACKING LIST
■
Power head with upper boom assembly
■
Lower boom with string head assembly
■
Front handle assembly
■
Guard
■
Grass deflector
■
Pro cut II string head
■
Cutting line
■
Shoulder strap
■
Operator’s manual
■
Figure sheet
■
Engine oil
■
Combination wrench
WARNING
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
ATTACHING THE FRONT HANDLE
(Fig. 2a)
■
Remove the securing screws and clamp from the front
handle.
■
Align the hooks on the clamp into upper shaft slot.
■
Install the front handle onto the upper shaft.
NOTE:
The front handle should tilt slightly towards the
operator when correctly fitted.
■
Place the securing screws through the front handle
and securely tighten them into the captive nuts on the
front handle.
NOTE:
Do not attempt to remove the locks on the
clamp, the locks limit the upper position of the front
handle.
ATTACHING THE GUARD AND GRASS DEFLECTOR
(Fig. 2b)
■
Attach the guard to the mounting bracket and align
the screw holes on the guard to the screws on the
mounting bracket.
■
Using the combination wrench, tighten all two screws
securely.
■
To attach the grass deflector to the guard, align the 3
screws on the grass deflector to the screw holes on
the guard.
■
Use the combination wrench to tighten the screws
securely.
ATTACHING THE POWER HEAD TO THE TRIMMER
ATTACHMENT
(Fig. 2c)
WARNING
If any parts are damaged or missing, do not