Ryobi RLT-300, Owner'S Operating Manual

Page: 10 / 16

oPErATIon
TrImmInG
1. Use the trimmer at an angle of approximately
15-degree to the working area
(Fig.7)
.
2. Slowly swing the trimmer from side to side.
(Fig.8)
3. Do not overload your trimmer, take small “bites”
this will keep machine operating at high speed
and will greatly improve cutting efficiency,
(Fig.9)
.
4. Cutting close to a wall
Use the outside edge of the guard as a guide
when cutting close to an edge.
mAnuAllY FEEd lInE
(Fig.10)
If required line can be fed out manually, press and
release manual line feed button (11), whilst gently
pull out the lines until the lines reach the line
cutter.
When the required amount of line is fed out, gently
pull on the second line (there is no need to press
the manual line feed button again)
If the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool cap
and click spool anti-clockwise until the line is at the
desired length.
9
Fig. 7
Fig. 8
Fig. 9
Fig. 10
11