Ryobi RLT-300, Owner'S Operating Manual

Page: 8 / 16

ASSEmBlY
Warning! do not connect the machine to the mains socket before it is completely assembled.
FITTInG AuXIlIArY HAndlE
(Fig.1)
noTE: This may already be pre-fitted to the
trimmer. However the following instructions
give full assembly details.
1. Locate the auxiliary handle (3) to the bracket.
Note its orientation.
2. Insert the bolt through the bracket and the
handle and screw into the captivated nut.
Tighten using the auxiliary handle locking knob
(4).
FITTInG GuArd
(Fig.2)
1. Fit the safety guard (9) into the slot on motor
housing, and then turn the safety guard till the
screw holes on the safety guard and motor
housing (8) are aligned.
2. Secure the safety guard onto the motor housing
with screws provided.
AdJuSTInG AuXIlIArY HAndlE (Fig. 3)
The angle of the auxiliary handle can be fully adjusted
in your most suitable position.
1. Loosen the auxiliary handle locking knob (4), and
adjust the angle of the auxiliary handle in the
direction of the shaft and also in a circumferential
direction of the shaft.
2. Turn the knob until the handle is securely tightened
note : For trimming, adjust the handle upward. For
edging adjust it downward.
7
3
4
Fig. 1
Fig. 2
8
9
Fig. 3
4
3