![background image](http://html1.mh-extra.com/html/ryobi/rj150v-01/rj150v-01_operators-manual_1506571004.webp)
Page 4
RULES FOR SAFE OPERATION (Continued)
■
STAY ALERT. Watch what you are doing and use
common sense. Do not operate tool when you are
tired. Do not rush.
■
CHECK DAMAGED PARTS. Before further use of
the tool, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced by an authorized
service center unless indicated elsewhere in this
instruction manual.
■
DO NOT USE TOOL IF SWITCH DOES NOT
TURN IT ON AND OFF. Have switches replaced by
an authorized service center.
■
CUTTING INTO ELECTRICAL WIRING IN WALLS
CAN CAUSE BLADE AND METAL PARTS TO
BECOME ELECTRICALLY LIVE. Grasp only the
handle(s) provided on the tool and be sure that
hidden electrical wiring, water pipes, or any me-
chanical hazards are not in blade path.
■
Inspect for and remove all nails from timber before
cutting.
■
DRUGS, ALCOHOL, MEDICATION. Do not oper-
ate tool while under the influence of drugs, alcohol,
or any medication.
■
WHEN SERVICING USE ONLY IDENTICAL
RYOBI REPLACEMENT PARTS.
■
POLARIZED PLUGS. To reduce the risk of electric
shock, this tool has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do
not change the plug in any way.
■
WARNING: TO AVOID POSSIBLE SERIOUS IN-
JURY, KEEP HANDS AND FINGERS FROM BE-
TWEEN THE MOTOR HOUSING AND SAW
BLADE CLAMP.
■
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who may
use this tool. If you loan someone this tool, loan
them these instructions also.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool overheating,
use an extension cord that is heavy enough to carry the
current the tool will draw.
A wire gage size (A.W.G.) of at least 14 is recommended for
an extension cord 50 feet or less in length. A wire gage size
(A.W.G.) of at least 12 is recommended for an extension cord
50 - 100 feet in length. When working outdoors, use an
extension cord that is suitable for outdoor use. The cord's
jacket will be marked WA.
CAUTION:
Keep extension cords away from the cutting area and
position the cord so that it will not get caught on lumber,
tools, etc. during cutting operation.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use tool with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
SAVE THESE INSTRUCTIONS
WARNING:
If any parts are missing, do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not allow familiarity with your saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
Summary of Contents for RJ150V-01
Page 11: ...Page 11 NOTES...