Ryobi R866011, Operator'S Manual

Page: 5 / 24

5 - English
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:

Removing and installing threaded fasteners
INSTALLING/REMOVING THE BELT HOOK
(NOT INCLUDED)
See Figure 1, page 8.

Align hole in belt hook with hole in tool’s base.

Install screw to secure belt hook in place.

To uninstall, remove screw and then belt hook.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 8.
฀

Insert the battery pack into the product as shown.
฀ 
Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
฀

Depress the latches to remove the battery pack.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
LOCK OUT LEVER
See Figure 3, page 8.
The lock out lever reduces the possibility of accidental start-
ing. The lock-lever must be in the unlocked position before
you pull the switch trigger. When not in use, slide lock-lever
up to lock the switch trigger.
VARIABLE SPEED SWITCH TRIGGER
See Figure 4, page 9.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, move the lock out lever to the unlocked
position and depress the switch trigger. To turn it OFF,
release the switch trigger and allow the tool to come to a
complete stop.
ASSEMBLY
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
FEATURES
PRODUCT SPECIFICATIONS
Anvil .......................................................................... 3/8 in.
No Load Speed .......................................0 - 250/min RPM
Maximum Torque ..................................................55 ft-lbs.