![background image](http://html1.mh-extra.com/html/ryobi/pblms01/pblms01_operators-manual_1506536026.webp)
26 − English
Fig. 33
C-CLAMP
COMPOUND MITER CUT
Fig. 34
45
°
X 45
°
COMPOUND MITER CUT
OPERATION
TO COMPOUND MITER CUT
See Figures 33 - 34.
A compound miter cut is a cut made using a miter angle and
a bevel angle at the same time. This type of cut is used to
make picture frames, cut molding, make boxes with sloping
sides, and for certain roof framing cuts.
To make this type of cut the control arm on the miter table
must be rotated to the correct angle and the saw arm must
be tilted to the correct bevel angle. Care should always
be taken when making compound miter setups due to the
interaction of the two angle settings.
Adjustments of miter and bevel settings are interdependent
with one another. Each time you adjust the miter setting you
change the effect of the bevel setting. Also, each time you
adjust the bevel setting you change the effect of the miter
setting.
It may take several settings to obtain the desired cut. The
first angle setting should be checked after setting the second
angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been
obtained, always make a test cut in scrap material before
making a finish cut in good material.
NOTE:
It may be necessary to adjust the partial sliding fence
to ensure proper clearance prior to making the cut.
Slide the saw head to its most rearward position and
tighten the slide lock knob securely.
Pull out the lock pin and lift saw arm to its full height.
Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
Rotate the control arm until the pointer aligns with the
desired angle on the miter scale.
Release the detent release lever, then tighten the miter
lock knob to secure the miter table.
Loosen the bevel lock knob and move the saw arm to
the left to the desired bevel angle.
Bevel angles can be set from 0° to 45°.
Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
Recheck miter angle setting. Make a test cut in scrap
material.
Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board could collapse on the blade at the end of the
cut, jamming the blade.
See Figures 42 - 43.
When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table.
See Figure 35.
Press the LED switch.
Lower the blade and align the cutting line on the workpiece
with the edge of saw blade or the blade shadow.
PARTIAL
SLIDING FENCE