9 - English
ANGLE CUTTING (BEVEL CUTTING)
See Figures 11-12, page 12.
Bevel cutting angles may be adjusted from 0° to 45° right
or left. Angles for cuts from 0° to 45° in 15° increments are
marked on a scale on both the left and right side of the base.
Notches on the underside of the base provide positive stops
at each of the above mentioned 15° increments. A protractor
is recommended when accurate cuts are required.
Remove the battery pack.
Remove the hex key from the storage compartment.
Loosen the two base pivot screws until the base can be
moved.
NOTE:
Do not completely remove screws.
Slide the base backward until the base can move freely
left and right.
OPERATION
Align the pointer on the housing with the desired angle
indicated on the scale on the saw base.
Once the desired angle is reached, slide base forward until
the tab on the motor housing aligns with the appropriate
notch on the underside of the base.
NOTE:
When making a set-up for accurate cuts with
a protractor, or for angles other than the preset 15°
increments, the positive stop notches on the underside
of the base are not used.
Tighten the base pivot screws securely.
Return the hex key to the storage compartment.
Reinstall the battery pack.
ACCESSORIES
Look for these accessories where you purchased this product or call 1-800-525-2579:
Edge Guide Kit
.................................................................................................................................................202936001
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 10
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
