9 — English
OPERATION
INSTALLING/REMOVING POWER CORD
See Figure 2, page 13.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
Insert the female end of the power supply cord into the
product as shown until it clicks into place.
Connect the male end of the power cord to the power
source.
Make sure the power cord is secured before beginning
operation.
To remove the power cord, unplug the cord from the
power source.
Press the release button on the top of the female end of
the power supply cord and remove from the tool.
DIRECTION OF ROTATION SELECTOR
(CLOCKWISE/COUNTERCLOCKWISE/CENTER LOCK)
See Figure 3, page 13.
Set the direction of rotation selector in the
OFF
(center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger in the
F/R
(forward/retract) position to rotate
the cable clockwise. Position the selector to the right of the
switch trigger in the
N
(neutral) position to rotate the cable
counterclockwise.
NOTE:
The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTE:
For optimal performance, position both the direction of
rotation selector and the direction of feed collar as described
later in the
Feed and Rotation Chart
.
NOTICE:
To prevent gear damage, always allow the cable to come to
a complete stop before changing the direction of rotation.
WARNING:
Hybrid tools are always in operating condition. Therefore,
lock the switch trigger when not in use or carrying at your
side, when installing or removing the battery pack, when
connecting or disconnecting the power cord, and when
manually advancing or retracting the cable. Failure to
follow these instructions could result in serious personal
injury.
VARIABLE SPEED SWITCH TRIGGER
See Figure 4, page 14.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool
ON
, depress the switch trigger. To turn it
OFF
, release the switch trigger and allow the cable to come
to a complete stop.
FEED DIRECTION SELECTOR COLLAR
See Figures 5 and 6, page 14.
The drain auger has three operating modes: forward (
F
),
neutral (
N
), and retract (
R
). In the forward (
F
) position,
squeezing the switch trigger will rotate and advance the
cable. When the tool is in retract (
R
) position, the cable
will rotate and retract as the switch trigger is squeezed. If
the drain auger is in neutral (
N
), the cable will not rotate,
advance, or retract.
NOTE: Never run the tool while the collar is pushed in
and in the neutral (N) position. Doing so will cause the
cable to kink.
To switch between modes:
Lock the switch trigger by placing the direction of rotation
selector in
OFF
(center lock) position.
Pull the feed direction selector collar away from the tool
and rotate it until the feed indicator is pointing at your
desired operating mode.
Push the collar toward the drum until it clicks into place.
NOTE:
The drum will rotate in the same direction
regardless of the direction of feed.
NOTE:
For optimal performance, position both the
direction of rotation selector and the direction of feed
collar as described later in the
Feed and Rotation Chart
.
WARNING:
Be careful when adjusting the feed direction selector
collar, keep fingers and cord away from pinch points.
Failure to heed this warning could result in fingers being
pinched or the cord being damaged.
