9 — English
wARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
wARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
ADJUSTING TORQUE
See Figure 3, page 11.
There are twelve torque indicator settings located on the
front of the screwdriver.
Rotate adjustment ring to desired setting, aligning num-
ber on adjustment ring with arrow on housing.
• 1 - 2
For driving small screws
• 3 - 4
For driving screws into soft material
• 5 - 7
For driving screws into soft and hard
materials
• 8 - 9
For driving screws into hard wood
• 10 - 11 For driving large screws
•
For full power applications
DIRECTION OF ROTATION SELECTOR
(FORwARD/REVERSE/CENTER LOCk)
See Figure 4, page 11.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
screwdriver held in normal operating position, the direction
of rotation selector should be positioned to the left of the
switch trigger for forward motion. The direction is reversed
when the selector is to the right of the switch trigger.
Setting the switch trigger in the
OFF (center lock) position
helps reduce the possibility of accidental starting when not
in use.
CAUTION:
To prevent gear damage, always allow the collet to
come to a complete stop before changing the direction
of rotation.
To stop the screwdriver, release the switch trigger and allow
the collet to come to a complete stop.
NOTE: The screwdriver will not run unless the direction of
rotation selector is pushed fully to the left or right.
TO LOAD/RELEASE BITS
See Figure 5, page 11.
The SPE™ SYSTEM on the screwdriver is a quick
change chuck designed to accept any 1/4 in. hex bits.
Insert
the bit into the chuck and push as far as possible until the
chuck locks onto the bit. To remove a bit, push rubber collar
forward, and then pull the bit straight out of the chuck.
LED wORkLIGHT
See Figure 6, page 11.
The screwdriver has a built-in LED worklight. This feature is
convenient when working in close or tight areas where
additional light is needed. Whenever the switch trigger is
depressed, the LED worklight will illuminate.
NOTE: During normal operation, if the LED worklight will not
illuminate, charge the screwdriver.
OPERATION
MAINTENANCE
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
BATTERIES
This product is equipped with a lithium-ion rechargeable
battery. Length of service from each charging will depend
on the type of work you are doing.
The battery in this product has been designed to provide
maximum trouble-free life. However, like all batteries, it will
eventually wear out.
To obtain the longest possible battery life, we suggest the
following:
Remove the product from the charger once it is fully
charged and ready for use.
For product storage longer than 30 days:
Store the product where the temperature is below 80°F.
Store the product in a “discharged” condition.
NOTE: RECyCLING INFORMATION AND FIGURES (ILLUSTRATIONS) START ON PAGE
10 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
