background image

2

ENGLISH (Original Instructions)

■   If  you  experience  any  of  the  symptoms  of  this 

condition, immediately discontinue use and see your 

physician about these symptoms.

 WARNING

The product is not intended for use by persons 

(including children) with reduced physical, sensory 

or mental capabilities, or lack of experience and 

knowledge, unless they have been given supervision 

or instruction concerning use of the product by a person 

responsible for their safety.

Children should be supervised to ensure that they do 

not play with the product.

SPECIFIC SAFETY RULES FOR TRIMMER USE

■   Replace  line  head  if  cracked,  chipped,  or  damaged 

in any way. Be sure the line head is properly installed 

and securely fastened. Failure to do so can cause 

serious injury.

■   Make sure all guards, straps, deflectors and handles 

are properly and securely attached.

■   Use  only  the  manufacturer's  replacement  line  in 

the  cutting  head.  Do  not  use  any  other  cutting 

attachment.

■   Never operate the product without the grass deflector 

in place and in good condition.

■   Maintain a firm grip on both handles while trimming. 

Keep  line  head  below  waist  level.  Never  cut  with 

the line head located over 76 cm or more above the 

ground.

SAFETY INSTRUCTIONS FOR POWER HEADS

■   Always  stop  the  engine,  remove  the  spark  plug 

wire, and allow the product to cool before refuelling, 

cleaning, maintenance or storage.

■   The product is very noisy when operating, to prevent 

long term hearing damage, wear hearing protection 

and  keep  other  persons  15m  away  from  the  work 

area. Operating similar tools nearby increases risk of 

injury.

■   Use of hearing protection reduces your ability to hear 

warnings (shouts or alarms). The operator must pay 

extra attention to what is going on in the work area.

■   Always  drain  the  fuel  tank  outdoors,  well  away  from 

sparks, flames and other sources of ignition. Allow 

the engine to cool before draining.

■   Always  refuel  outdoors  in  a  well  ventilated  area 

away from sparks, flames and other ignition sources. 

Choose a hard level surface for this task.

■   Always  mix,  transport  and  store  fuel  in  a  container 

approved for petroleum.

■   Never store the product with fuel in the tank inside a 

building where there could be sources of ignition. e.g. 

heating and water boiler's etc.

STORING THE PRODUCT

Storing the product differs depending on the amount of
time it will be in storage.

TO STORE THE PRODUCT SHORT TERM 

Follow these steps to store the product short term.

■   Clean all foreign material from the product.
■   Store  the  product  in  a  well-ventilated  place  that  is 

inaccessible to children.

TO STORE THE PRODUCT LONG TERM

If you do not intend to use the product for more than one
month, follow the storage procedures below.
Follow these steps to store the product long term.

■   Drain  all  of  the  fuel  from  the  tank  into  a  container 

approved for petrol.

■   Run the engine until it stops.
■   Clean all foreign material from the product.
■   Store  the  product  in  a  well-ventilated  place  that  is 

inaccessible to children.

 NOTE:

  Keep  the  product  away  from  corrosive 

agents such as garden chemicals and de-icing salts. 

Important: Abide by all local regulations for the safe 

storage and handling of petrol.

■   Never  start  or  run  the  engine  in  a  closed  or  poorly 

ventilated area; breathing exhaust fumes can kill.

■   Inspect  the  product  before  each  use  for  loose 

fasteners, fuel leaks, etc. Replace any damaged 

parts before use.

■   Keep  petrol  and  oil  away  from  the  eyes.  If  petrol 

or oil comes in contact with the eyes, wash them 

immediately with clean water. If irritation is still 

present, see a doctor immediately.

■   Ensure to properly close and tighten the caps on both 

fuel tanks and fuel containers.

■   To reduce the fire hazard, keep the engine, silencer, 

and petrol storage area free of grass, leaves or 

excessive grease.

WARNING

Always shut off engine before fuelling. Never add 

fuel to a machine with a running or hot engine. 

Clean  up  any  spillages  and  move  at  least  9m 

from  refuelling  site  before  starting  engine.  Do 

not smoke!

Summary of Contents for EXPAND-IT ALT04G













Reviews: