3
English
GB
FR
DE
ES
IT
NL
PT
DK
SE
FI
NO
RU
PL
CZ
HU
RO
LV
LT
EE
HR
SI
SK
GR
TR
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SPECIFICATIONS
Wheel diameter
115 mm (4.5 in)
Thickness
6 mm
Voltage
230 V - 240 V 50 Hz
Input
600 W
Spindle thread
M14
Rated speed
12,000 min
־
¹
Overall length
325 mm
Net weight
2.0 kg
NOTE:
Be sure to check the nameplate on the product,
because the voltage is subject to change depending on
the area in which the product is to be used.
Maximum circumferential speed of grinding wheel: 4,800
m/min.
Example of calculation
3.14 x 115 x 12,000/1,000 =
4,330
Circumferential speed of
grinding wheel
4,330
Wheel diameter
115
Rated speed of grinder
12,000
STANDARD ACCESSORIES
Auxiliary handle, Wrench.
A grinding wheel is included in the standard accessories
for some countries.
APPLICATIONS
Use only for the purposes listed below:
Grinding metals
OPERATION
See
fi
gure 3.
WARNING
Keep safety guards in place. Never cover the air vents
since they must always be open for proper motor
cooling.
The key to ef
fi
cient operating is controlling the pressure
and surface contact between the disc and work piece. Flat
surfaces are ground at an acute angle, usually 10 to 20
degrees with the work piece. Allow the disc to reach full
speed before starting to grind. Too great an angle causes
concentration of pressure on a small area which may
gouge or burn work surface.
SWITCH
See
fi
gure 2.
1. This tool is started and stopped by sliding and
releasing the switch.
2. For the convenience of continuous operation, slide the
switch along then press the front end down to lock it.
3. To release the lock, press the rear end of the switch.
MOUNTING THE GRINDING WHEEL
See
fi
gure 4 - 5.
1. Attach the disc
fl
ange and the wheel on the spindle
before
fi
tting the clamp nut.
2. Ensure that the wheel is correctly seated over the boss
on the disc
fl
ange and clamp nut.
3. Depress the lock button located on the right side of
gear case.
4. Using the wrench provided, tighten the clamp nut in a
clockwise direction.
WARNING
Check carefully whether or not there are cracks in the
wheel. Replace a cracked wheel immediately.
WHEEL GUARD ADJUSTMENT
See
fi
gure 6.
WARNING
Never use the angle grinder without the wheel guard in
place properly adjusted.
1. Unplug the tool.
2. Using the spindle lock button and wrench provided,
loosen and remove the clamp nut, grinding disc and
