10
ENGLISH(Original Instructions)
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Pressure
washer
does not
start when
trigger is
depressed
Power cord not
connected to power
source
Switch is off
House circuit breaker is
tripped
Connect the power cord to a live 220-240V AC, 50 Hz AC socket.
Turn switch on.
Reset house breaker. Make sure pressure washer is connected to an
individual branch circuit only. If using an extension cord, make sure it
is heavy enough to carry the current of the pressure washer.
Pump
doesn’t
produce
pressure
Inadequate water
supply
Lance leaks
Nozzle is clogged
Pump is faulty
Air in line
Water inlet filter is
clogged or dirty
Provide adequate water flow. Turn water supply off. Remove self-
coiling hose on pressure washer inlet side (do not lose gasket). Turn
tap on to check water flow. If there is no water, fix water supply
issue. If there is water, check other troubleshooting solutions.
Check connections and / or replace lance.
Clean nozzle.
Contact authorized service centre.
Squeeze trigger on gun to remove air from line.
Remove the water inlet filter, rinse with warm water, then replace in
unit.
Machine
doesn’t
reach high
pressure
Water supply is
restricted
Not enough inlet water
Check garden hose for kinks, leaks, and blockages.
Open water source full force.
No
detergent
Detergent tank is empty
Water supply is
inadequate or clogged
Wrong nozzle is
attached.
Add additional detergent to tank.
Check garden hose for kinks, leaks and blockages.
Attach Low Pressure nozzle.
DISPOSAL
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
