![background image](http://html.mh-extra.com/html/ryobi/csb122/csb122_operators-manual_1506397018.webp)
18
OPERATION
0° BEVEL STOP
See Figure 19.
The saw has a 0° bevel stop that has been factory adjusted to
assure 0° angle of the saw blade when making 90° cuts.
To check 0° bevel stop:
Unplug the circular saw.
Place the saw in an upside down position on a work-
bench.
Check the squareness of the saw blade plate
to the base
of the saw using a combination square.
To adjust 0° bevel stop:
Unplug the circular saw.
Loosen wing nut.
Loosen hex nut securing adjusting screw.
Turn screw and adjust base until square with saw
blade.
Tighten hex nut and wing nut securely.
WARNING:
Attempting a bevel cut without having the wing nut
securely tightened can result in serious injury.
LENGTH OF CUT SCALE
See Figure 20.
The saw is equipped with a length of cut scale on its base.
It is parallel with the saw blade and can be used to measure
the distance into the material the blade cuts.
NOTE:
Six inches is the maximum length of cut that you can
measure. Also, it is accurate only when the depth of cut is
set at full maximum depth.
Fig. 0
HEX NUT
WING NUT
CARPENTER’S
SQUARE
LENGTH OF CUT SCALE
Fig. 19