18
ASSEMbLy
TO CHECK AND ALIGN THE SPREADER, SAw
bLADE, AND bLADE GUARD ASSEMbLy
See Figure 14.
If the blade guard assembly is out of alignment with the saw
blade, adjust the alignment of the blade guard assembly. The
spreader must be aligned with the saw blade.
To check alignment of the spreader:
Unplug the saw.
Raise the saw blade by turning the height/bevel adjusting
handwheel counterclockwise.
Lift the anti-kickback pawls and place a framing square
or straight edge against both the saw blade and the
spreader.
The saw blade and spreader are aligned when the framing
square contacts both the blade and spreader evenly with
no gaps.
If the spreader and saw blade are not in alignment,
adjustment is needed. To adjust:
Unplug the saw then raise the blade guard assembly.
Loosen the wing nut holding the blade guard assembly
to the mounting bracket.
Reposition the blade guard assembly left or right as
needed to align the spreader with the saw blade.
Once properly aligned, securely retighten the wing
nut.
TO ASSEMbLE THE SLIDING EXTENSION
TAbLES
See Figures 15 - 16.
The rear extension rods are longer than the front extension
rods and must be inserted into the plastic brackets under
the saw table first.
Locate the left sliding extension table and slide the
extension rods into the plastic brackets under the saw
table.
Push the extension table until it rests against the saw
table and is completely closed.
Position the end plug (LF) over the extension rod (the side
with the screw hole and detent facing out) and slide into
place.
Locate the left indicator.
NOTE: the indicators are clearly marked with and “RF”
(right) or a “LF” (left).
Thread the indicator (LF) into the slot in the front rail.
Fit the top slot in the indicator over the detent and the
bottom slot over the screw hole.
Insert a screw into the bottom slot of the indicator, the hole
in the end plug and the extension rod. Finger-tighten.
Fig. 14
SPreader
FraMinG
Square
Fig. 15
SCreW
end
PluG
leFt SlidinG
extenSion
taBle
riGHt SlidinG
extenSion
taBle
indiCator (lF)
extenSion
rod