Ryobi AP1305, Operator'S Manual

Page: 18 / 60

Page 18 — English
PROBLEM POSSIBLE CAUSE SOLUTION
Snipe (depressions at ends of
workpiece) Dull cutter blades
Incorrect butted stock
Unit not securely mounted Replace or turn cutter blades.
Butt pieces end-to-end as they are
fed into planer.
Tighten lag bolts.
Torn grain Too deep a blade setting
Workpiece being fed against grain
Dull cutter blades Reduce depth of cut.
Feed other end of board first.
Replace or turn cutter blades.
Fuzzy/rough grain High wood moisture content
Dull cutter blades
Too deep a blade setting
Incorrect feeding speed Dry wood before planing.
Replace or turn cutter blades.
Reduce depth of cut.
Check for adequate power supply.
Check cord and plug for damage.
Check condition of motor brushes.
Uneven depth of cut Cutter head assembly not level with
planer surface
Unstable roller spring pressure
Feed roller worn unevenly Have service performed by an
authorized service center.
Have service performed by an
authorized service center.
Have service performed by an
authorized service center.
Board thickness does not match
depth scale indicator Depth scale incorrectly set
Dirty planing table Adjust depth scale.
Clean and wax planing table.
Cutter head height difficult to
adjust Dirty elevation spindle
Worn chain Clean and lubricate spindle.
Have service performed by an
authorized service center.
Will not start Not plugged in
Blown circuit
Motor failure
Loose wire
ON/OFF switch malfunction
Motor is overloaded Check power source.
Replace fuse, reset breaker, or call
electrician.
Have service performed by an
authorized service center.
Have service performed by an
authorized service center.
Have service performed by an
authorized service center.
Push reset button.
Interrupted operation Unit overloaded
Circuit overloaded Reduce load.
Operate on circuit separate from other
appliances or motors or connect to
circuit with adequate amp rating.
TROUBLESHOOTING