Inspex II User Manual
15 |
P a g e
INSPEX II English Rev 1.06, SW Rev 1.06
Settings:
Network:
The Inspex II supports Networking via the Ethernet port on the back. The network settings (Fig. 6)
can be configured automatically using (DHCP) Dynamic Host Configuration Protocol or manually by
assigning a Static IP, Network Mask and Default Gateway.
To configure the DHCP ,the Inspex II
must
be connected to a network via a straight ethernet cable.
Select DHCP and press apply and the network configuration will be automatically applied.
To configure the network with a Static IP, select Static IP and enter Static IP, Network Mask and
Default Gateway. Press Apply and the Networks Settings will be updated with the changes.
Inspex II SFTP Network connection:
The Inspex II supports ( SFTP ) Secure File Transfer Protocol, allowing all files to be accessed from the
Inspex II as a Read Only Drive. Any operating system software that supports SFTP should work but
below is software that has been verified by Ash Technologies.
For
Microsoft Windows
, Ash Technologies has tested and recommends WinSCP. This is open source
When using this software, “Host” is the
Inspex II IP address which can be found in Settings/Network.
For
Linux
this is already supported in the mainline distributions.
For
Android
Turbo Client has been tested and verified to work.
Username:
network
Password:
The network password needs to be set if you want to connect the Inspex II
to a network.
The User can then change the password by entering a new password and clicking Apply.
Fig 6.
