GB-8
Jr.
Sodcutter
FIGURE 9
Honda Engine Shown
13.
For Briggs engines loosen and remove two
(2) 10mm screws securing throttle cover to
engine. Pivot throttle cover forward to allow
access to throttle. See Figure 10.
1
1
2
5390
1
2
3
4
5389
5
FIGURE 10
1. Throttle Cover on Briggs Engines
14.
For Honda engines loosen and remove wing
nut securing air cleaner cover. Remove
cover and element to allow access to
throttle. See Figure 11.
FIGURE 11
1. Wing nut on Honda Engines
15.
For Briggs engine route throttle cable to
engine and secure with clamp and hardware
as shown in Figure 12 (for Honda engines
route cable to the inside of bracket).
FIGURE 12
Briggs Engine Shown
1. Cable Clamp
2. Throttle Cable
16.
For Briggs engines route throttle cable
through throttle bracket as shown in Figure
13. The cable end shoulder should be
positioned as shown against the end of the
throttle bracket. Crimp throttle bracket
against throttle cable making sure not to
excessively deform bracket by overtighting.
YELLOW
WIRES
RED WIRES
FROM
OPERATOR
PRESENCE
SWITCH
1
5393
FIGURE 13
Briggs Engine Shown
1. Throttle Cable
2. Throttle Bracket
3. Cable Stop
4. Cable End Shoulder
5. Throttle Stop Screw
17.
For Honda engines route throttle cable
through throttle bracket as shown in Figure
14. The cable end shoulder should be
positioned as shown against the end of the
throttle bracket. Tighten down throttle bracket
making sure not to overtighten.
SET-UP
