background image

3

1.  WARNINGS

IMPORTANT NOTICE

These instructions are for the use of qualified individuals
specially trained and experienced in installation of this type
equipment and related system components.

Installation and service personnel are required by some states
to be licensed.  PERSONS NOT QUALIFIED SHALL NOT
INSTALL NOR SERVICE THIS EQUIPMENT.

NOTE

The words “Shall” or “Must” indicate a requirement which is
essential to satisfactory and safe product performance.

The words “Should” or “May” indicate a recommendation or
advice which is not essential and not required but which may
be useful or helpful.

WARNING

DO NOT PERFORM A DIELECTRIC
STRENGTH TEST (HYPOT) ON 6636
SERIES AIR CONDITIONERS.  
DAMAGE TO PRINTED CIRCUIT
BOARD MAY RESULT.

WARNING - SHOCK HAZARD

To prevent the possibility of severe personal injury or
equipment damage due to electrical shock, always be sure
the electrical power source to the appliance is
disconnected.

CAREFULLY FOLLOW ALL INSTRUCTIONS AND
WARNINGS IN THIS BOOKLET TO AVOID DAMAGE
TO THE EQUIPMENT, PERSONAL INJURY OR FIRE.

WARNING

Improper installation may damage equipment, can create
a hazard and will void the warranty.

The use of components not tested in combination with
these units will void the warranty, may make the
equipment in violation of state codes, may create a hazard
and may ruin the equipment.

2.  COMPONENT MATCH-UP

1.

6636 Series Package Air Conditioner.  (Reference
specifications for model number breakdown and
identification.)

2.

6795*3451, 6636-3471 or the 6636-345* Electronic
12 VDC Wall Mounted Thermostat.  These
thermostats are pre-wired to two electrical 

connectors.  Both the thermostat supply and control
wiring can be quickly attached (plugged in) to the
thermostat.

3.

6795C4351 35' thermostat cable with connector
plugs for termination at both the air conditioner and
electronic thermostat.

3.  UNIT IDENTIFICATION

PACKAGE AIR CONDITIONER MODEL NUMBER BREAKDOWN FOLLOWS:

6

6

3

6

A

8

7

1

Sub-Mounted Unit

High Efficiency

Non-Exhaust

24,000 BTU

12 VDC Control

PTCR/Start Capacitor

Tecumseh Compressor

Revision

Letter

Summary of Contents for 6636 Series













Reviews: