![background image](http://html1.mh-extra.com/html/rutus/argo-ne/argo-ne_user-manual_1503193005.webp)
The picture below shows the functions of individual buttons on the control panel.
The detector is turned on by pressing the button with the power icon.
The detector can
be turned off only from the operation mode by holding the button for 1 second.
In the
menu the button is used only to enter the tones editing screen. A short press of the button in
the operation mode does not turn the detector off but changes to the operation mode selection
screen.
After turning the detector on, the ground balance procedure must be completed. This can
be done at any time by pressing the button. When the message « Put search coil UP Then
pull trigger » is shown, the search coil should be lifted at least 0.5 m above the ground, and then
the trigger should be pulled. The display will then show the « Preparing Data » message, this
means that the processor is collecting the data necessary for operation. After this process ends
the « OK » message will appear followed by the main screen of ground balance (see picture
below).
Correct ground balance is gained by „pumping”. The search coil
should be slowly moved up and down above the ground, each cycle
taking about a second. The detector will display the number of cycles
remaining – decreasing from 5 to 1 and after the last movement up the
message « Detector ready, pull trigger » will be shown. After pulling the
trigger, the soil phase reading will be gathered and after about 2 seconds the detector will be
ready for searching.
RUTUS
Argo NE
4
Summary of Contents for Argo NE
Page 1: ......