INSTALLATION AND SETUP
RUSTIBUS®
2000
LOW
ELECTRIC
Before you begin.
Step 1: VERIFY THE COMPLETENESS OF YOUR RUSTIBUS® MACHINE.
•
Check that all components are attached properly and in a proper / safe working order.
(Check that there are no loose wires, guards or parts on the machine)
Step 2: ASSOCIATED EQUIPMENT.
• Ensure that you have the correct cable and plugs to correspond with the voltage of the
machine and the power source you are using.
• We recommend the use of an Earth Breaker device to ensure full safety for the operators.
Step 3: BEFORE COMMENCING THE OPERATION.
• Locate the section to be cleaned / de-scaled and determine if the area needs to be cleaned.
Excessive grease, dirt and other hazardous material should be cleaned from the surface area
before operation of the
Rustibus®
machine.
• The Chain drum is rotating at high RPM, show outmost care when connecting cable and when
operating machine.
ALWAYS THINK SAFETY FIRST!
• Connect your machine to its power source.
• Make sure the cable is properly connected and safely located for your operation.
•
ALWAYS
lift up machine (push down the handle) in order for the chain drum to rotate freely
when starting the machine.
• Start and Stop the machine and check that rotation is correct according to marking on
machine.
Step 4: OPERATION OF RUSTIBUS® MACHINE.
• For the best results from your
Rustibus®
machine you should run the machine forward and backward
over the area until appropriate result is achieved
•
Do not run the machine over sharp edges, but along them. Your machine will last longer if operated
with care.
Step 5: MAINTENANCE OF RUSTIBUS ® MACHINE.
•
ALWAYS
stop the machine and disconnect it from its power source before carrying out any
maintenance on the machine.
• Use the Disposable Chain Drum until it is completely destroyed and then replace the entire drum with
a new one.
Genuine Rustibus® parts only!
Machine may vary from pictures
