5
PAY ATTENTION TO THE FOLLOWING POINTS IN THE FIRST OPERATION OF THE WATER
DISPENSER:
1. In order to prevent any damage to the heating system; do not plug in the water dispenser
before water comes out of the hot water tap.
2. Do not switch the cooling function on within the first 6 hours of operation
3. If power failure has occurred within the first six hours of use; pay attention to the warnings
under the title of
“
IN CASE OF POWER FAILURE
”
DURING THE TRANSPORTATION
Original packages and foams may be required for transportation of your water dispenser.
Points to consider during re-transportation of the product;
•
Your water dispenser should be emptied and cleaned before the transportation.
•
Accessories of your water dispenser should be taped down to prevent movement during
transportation.
•
Condenser pipes on the back of the water dispenser should be protected against impact and
perforation before the packaging.
•
The packaged water dispenser should be securely packed into the transportation vehicle.
Packaging instructions on the box should be adhered to.
•
Your appliance should not be tilted more than 45° during the transportation. Should the water
dispenser be tilt
ed more than 45˚ or stored horizontally, it should be kept in a vertical (upright
position) for a minimum of 6 hours before operating.
NECESSARY ACTIONS FOR ENERGY SAVING
1. Do not put hot water into the water dispenser.
2. Do not place your water dispenser near heat emitting appliances such as an oven, dishwasher
or heater, or in direct sunlight.
3. Be sure to switch off the water dispenser if it is not going to be in use for a long period of time.
NOTE:
Empty the water dispenser completely, by opening the tap and letting all the water drain out.
Then open the drain valve at the back of the water dispenser and let the water drain out completely. If
water is left in the water dispenser for long periods of time, it will begin to smell and may cause
damage to the water tank.
