4
BEFORE USING FOR THE FIRST TIME
• Remove any labels, stickers or packaging from the steam station and iron soleplate.
• Remove the water tank and rinse with clean water.
• Before using the iron for the first time, or if it’s not been used for a long time, iron a scrap
piece of cotton or linen to remove any accumulated residues.
• The iron may give off an odour and small amount of vapour when switched on for the first
time. This is normal and will stop as the element cures.
AUTO SHUT-OFF
If you don’t press the steam trigger for 10 minutes your iron’s auto shut-off feature will operate.
The thermostat light and the on/off button will flash to tell you that it is in auto shut-off mode. To
cancel the auto shut-off mode, press the steam trigger. Note that your iron will need time to heat
up again. Wait until the temperature light has stopped flashing before resuming ironing.
FILLING/REFILLING
• Don’t add anything to the water and don’t use water with anything added to it. When the
water is converted to steam, chemicals, perfume, and other additives will coat the inside of
the steam chamber, shortening the life of the iron.
1. Press the water tank release button and
pull the water reservoir away from the
body of the steam generator (fig. A).
2. Fill the reservoir to the
max
mark. Do not
exceed the
max
mark.
3. Refit the reservoir into the base unit
pushing it in until it clicks.
• A warning light ( ) will come on and the
unit will beep twice when the reservoir
needs refilling. If the reservoir is empty, the steam function will stop working after one
minute, however, you can still use your iron without steam.
PRELIMINARY SETTINGS
1. Put the iron on top of the base unit.
2.
Put the plug into the power socket (switch the socket on, if it’s switchable).
3. Turn the unit on by pressing the on/off button.
USING
The temperature of your iron is safe to use on all ironable fabrics and garments.
DRY IRONING
1. Set the steam control to
2. When the temperature light stops flashing your iron is ready to use.
STEAM IRONING
1. Set the steam control to the setting you want, = no steam, = high steam.
2. Squeeze the steam trigger to produce steam, release it to stop.
• Your steam generator produces steam very efficiently so use the trigger in short, controlled
bursts. Too much steam can wet the fabric or cause condensation issues on your ironing
board. Steam can also be reduced by setting the steam control to a lower setting.
NOTE:
When you first start your steam generator and pull the trigger for steam ironing, there will
be a delay as your steam generator pumps water from the reservoir to prime the system. This is
normal and may take 20-30 seconds. This will also happen after refilling the reservoir.
3
MAX
t
h
A
h
B
u
C
h
C
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE
