To further prevent leaking water from the soleplate, do not press the burst of steam button
continuously for more than three (3) seconds. Allow at least a one (1) minute interval before
pressing the burst of steam button again. Stubborn creases should be removed within three
(3) burst of steam button presses.
VERTICAL STEAMING
Burst of steam can also be applied when holding the iron in a
vertical position. This function is useful for removing wrinkles on
garments in hanging position, hanging curtains, or other hanging
fabrics.
•
Check that there's adequate ventilation behind the fabric, otherwise moisture may
build up, causing mildew.
•
Check that there's nothing behind the fabric that may be damaged by the steam.
Check that pockets, turn-ups, and cuffs are empty.
•
Check that there's water in the reservoir.
•
Set the temperature control to max and set the steam control
•
Hold the iron close to (but not touching) the fabric.
•
Press the steam burst button.
•
Leave 4 seconds between shots, to let the temperature build up.
Note:
It may be necessary to press the burst of steam button few times to start this function.
During the use of ‘Burst of Steam’, stop ironing when the pilot light turns on and then start
ironing again only after the pilot light has turned off.
Warning: Do not apply steam on any clothes or fabrics that are being worn by human or
pets. The temperature of the steam is very high and will burn or scald.
DRY IRONING
This function irons without the use of steam.
If you're going to be dry ironing for 20 minutes or more, empty the reservoir first to avoid
spontaneous bursts of steam.
1.
Connect the iron with a suitable mains power supply outlet.
2.
Set the steam knob to position
“0”/ “no steam”/ “OFF”
.
