4
fitting the whisks/hooks
1 Switch off (
0
) before fitting or removing the whisks/hooks.
2 Align the pips on the shaft with the slots in the drive head.
3 Push the shaft into the drive head till it clicks into place.
4 Each whisk/hook must be fitted into a specific drive head.
5 The shaft with the flange fits the head with the large hole.
6 Use both whisks or both hooks, don’t mix them.
removing the whisks/hooks
7 Switch off (
0
) and unplug the mixer, then shake any excess
mixture into the mixing bowl.
8 Hold both whisks/hooks, to prevent them jumping out,
then press
5
to eject them from the drive heads.
on/off switch
9 Slide the switch right to switch on (
1
), left to switch off (
0
).
10 When you switch on, the whole display will light up, then
it’ll show ”SPEED” at the top left, “
0
” in the centre, and
“TIMER
00:00
” at the bottom.
speed buttons
11 Press and release
u
to increase the speed, till the speed
you want appears in the display.
12 Press and release
d
to decrease the speed.
13 Keep pressing to scroll quickly through the speeds.
14 The speed range is from 0 (stopped) to 16 (high speed).
15 The display will show “SPEED” at the top left, and the speed
(
0
to
16
) in the centre.
16 The figures below “TIMER” will show how long the motor
has been running, in minutes and seconds
17 To stop quickly, simply slide the on/off switch left (
0
).
the turbo button
Y
18 Pressing the turbo button will over-ride the speed set by
the speed buttons, and give you a burst of high speed.
Summary of Contents for 14332
Page 1: ...instructions ...
Page 2: ...2 ...
