Once the purging is complete, the burner will light and operate as indicated in the instruction manual. Subsequent lighting
of the appliance will not require such a purging unless the gas supply has been disconnected.
WARNING:
Read and follow the safety and lighting instruction page in this manual and on the labels on the appliance.
BY NOT FOLLOWING INSTRUCTIONS, A FIRE/ EXPLOSION MAY RESULT. YOU MAY BE SERIOUSLY INJURED.
BASIC SET UP
Once the Outdoor Gas Fireplace is in position, level and safely hooked up to the proper fuel supply; it is now time to install
the log grate over the plate burner. Next place the lava rock around the flat burner plate. DO NOT place the lava rock on
the burner plate as it will affect the flow of the flame. Next install the ceramic fire logs onto the grate. Start by laying one
log in the centre of the grate length wise. Lay the other logs, (quantity may vary by unit type), over the first log as in the
figure below (See Log Placement Picture referring to V-1000, 2000, 3000, 4000, 5000). For the V-6000 place 2 logs
length wise in the grate and position remaining logs over them in an angled position as shown in Placement Picture for
FRP-4300). Please ensure the logs are place securely to avoid any movement.
NOTE: Be sure unit is cool before
touching any of the components.
Log Placement Picture for: Log Placement Picture for:
V1000,V2000,V3000,V4000,V5000 V-6000
FOR YOUR SAFTY READ BEFORE LIGHTING
A. Before operating smell all around the appliance area for gas odors and next to the floor because some gases
are heavier then air and will settle on the floor.
B. Use only your hand to turn the manual gas control valve. Never use tools. If the valve will not turn by hand, do
not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or
explosion,
C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and replace any part of the control system and any gas control which has been under
water.
D. Make sure the ignitor battery has been installed properly. Ignitor will not operate properly without a battery
installed.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier’ from a neighbors phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
LIGHTING INSTRUCTIONS
