EN
14
At this point pull the starter string in the same way explained above until the engine starts
at full speed.
For the engine to run at idle, run the throttle lever and then release.
ATTENTION
Do not rush to the starter because you risk damaging the entire starter
assembly!
Shooting is always done by pretending the starter string.
Stopping the engine
Stopping the brushcutter engine is done as follows:
▪
Release the throttle lever and let the engine run for about 1 minute.
▪
Switch the on-off switch to position "0"
Checks required if the brushcutter does not respond to commands
When the motor don’t start:
Check that the on / off switch is in the “I” position.
• Check if there is enough fuel.
• Check that the priming pump is full of petrol.
• Check the spark plug for sparks.
• Check that the fuel mixture is not older than 7 days in good condition eighth
WARNING :
If the shoulder strap does not respond to commands or does not work
properly, you must contact an authorized Ruris service immediately.
7.1 BREAKING-IN
1.
The running-in must be done at idle and not in pregnancy. Three gas tanks
idling, no load. At intervals of 10-15 min it accelerates to the maximum, for 10-
15 sec, for the evacuation of unburned oil from the exhaust drum.
