Ruris 425, User Manual

Page: 16 / 26

15
Secure tightly the guide of the brush cutter with your left hand and
boldly pull the starter rope with your right hand.
Pulling the rope must be made in two steps. The first step will be
made by an easy pull of the starter until the rope has come out of
the starter roll about 150-200mm and you can fill the engine
compression. The second step will be pulling powerfully and greatly
without interruption (pull the starter rope until the level of your
shoulders) according to fig.15
Pulling is carried out until the engine starts. After which you gently
switch the air flap on the „open‟ position according to figure 13, until
the engine runs properly.
In order for the engine to work at idle, operate by gripping the
throttle lever.
ATTENTION ! Do not be brusque when pulling the starter because you
risk damaging the entire starter set.
Pulling is always made by prestressing the starter rope.
Fig. 15
2.2 Stopping the engine
Stopping the engine of the brush cutter is made as follows:

Release the throttle lever and let the engine to run for about 2
minutes.
 Push forward the switch in the „stop‟ position(STOP)