Ruris 425, User Manual

Page: 14 / 26

13
To balance the brush cutter in relation to the harness and the
user‟s height, you will need to perform the following maneuvers:
-
make sure that the mounting strap is located at a hand breadth under
the user‟s hip
-
Place the brush cutter in the harness‟ safety and release it
- If the brush cutter does not stay balanced and touch with the cutting
disc the ground surface or if the brush cutter tends to be inclined from
the engine, you will need to reposition the securing system placed on
the brush cutter guide towards the engine or the cutting disc until you
find the state point of the brush cutter, according to Fig. 12
In this case operation will be made with ease without supporting the
brush cutter in hands.
Fig. 12
2.0 Commissioning
Before commissioning the Ruris brush cutter you should make sure that the
following conditions are fulfilled:

Within a radius of 5 meters on both sides of the Ruris brush cutter,
there are no people or objects with which it could come into
contact;

The brush cutter is placed horizontally on the ground;

The cables are properly fixed, respond to commands by the checks
made, without starting the engine;

The handles are properly installed and fixed;

The reduction gear has graphite grease on the screw;

The engine oil has reached an adequate level, the level is indicated
at the first course of thread, outward. See figure

The engine has a minimum of 200 ml petrol in the tank;

The throttle handle is placed on the running position to maximum
and is locked in this position according to fig.11;
 The on/off switch is placed on the “on” position according to fig.14

The cutting disc is properly installed and fixed, secured with the
safety nut;

All the screws of the brush cutter are tightened accordingly.