25
Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
[email protected] | www.ruptela.com
4.3.2
Profile settings
The second part of the configuration tool is for profile settings. This section also contains explanations for
other features that need extensive configuration.
Each profile is a set of settings for specific circumstances (e.g. one profile can be used when the vehicle is
operated in the native country and a different one can be used when it is abroad).
The FM device will switch to a different profile if one of the following conditions is met:
An IO parameter with an active
Switch to
setting is triggered (see
IO settings
);
No suitable operators are found in the operator list in the current profile (see
Operator list
).
A red notification message will be displayed if:
Any IO parameter has an active
Switch to
setting;
Any operator is entered in the operator list;
Any operator is entered in the blacklist.
For IO parameters and the operator list, the message will also display which profile(s) contain the switching
conditions.
Sleep
can be
Disabled
or set to
Sleep
or
Deep sleep
. Sleep extends internal battery life by turning off
GPS/GSM modems. Deep sleep disables advanced peripherals (1-Wire, CAN1, CAN2, Serial Ports, K-Line).
When
Sleep
,
Deep sleep
or
Custom
is selected, it is possible to modify the
sleep timeout. Once this time limit is reached, the device will first check if
there are any unsent records, if there are no records pending, the device
will switch to the configured sleep mode. If there are records pending, the
timeout will be twice as long, but it will activate the selected sleep mode
disregarding the records in the buffer. By default, the timeout is set to 600 seconds.
If engine detection is set to
Always on
, the device will not go to sleep;
If DIN state is High (Value = 1), the device will not go to sleep or deep sleep mode;
The device cannot go to sleep, if Garmin is connected to it and switched on;
Any IO events (except those related to switched off peripherals, according to sleep configuration) that
are set to generate records on
High
priority will wake up the device.
