5
ELECTRIC CONNECTIONS
The arm is equipped with the following cables:
-
One 3 x 2.5 mm
2
cable, which supplies two 16 A sockets (item 1), marked by red tape.
-
One 3 x 2.5 mm
2
cable, which supplies one 16 A socket (item 2).
-
One 4 x 1.5 mm
2
cable, connected to the MAN-0-AUT switch.
The cables are connected in the standard way. Connections with external equipment are shown in the
diagrams enclosed to the above-mentioned elements.
NOTE REGARDING THE HB525P – HB625P ARM
-
One 3 x 2.5 mm
2
cable, which supplies two 16 A sockets (item 1), marked by red tape.
-
One 3 x 2.5 mm
2
cable, which supplies single 16 A socket (item 2).
-
One 2 x 1.5 mm
2
cable, for connection with the turbine control cable.
NOTE REGARDING THE HB525P – HB625P ARM
-
One 3 x 2.5 mm
2
cable, which supplies the whole arm.
-
One 2 x 1.5 mm
2
cable, for connection with the turbine control cable.
NOTE REGARDING THE HB525P – HB625P ARM
-
One 3 x 2.5 mm
2
cable, which supplies the whole arm.
-
One 2 x 1.5 mm
2
cable, for connection with the turbine control cable.
ATTENTION:
All 3 x 2.5 mm
2
cables, which supply the arm, should be connected to magnetothermal differential
switch – 6Ka – 30 mA, 16 A.
Only authorised and specialised personnel may perform the arm installation operations.
PNEUMATIC CONNECTIONS AND DUST EXTRACTION
The arm is equipped with the following tubes:
-
1 caoutchouc tube, cross-section 10 x 19, which supplies two quick connections (item 9).
Connect this tube to the compressed air system (max. pressure 8 bar).
-
1 caoutchouc tube, cross-section 6 x 14, which supplies one quick connection (item 10).
Connect this tube to the dry compressed air system (max. pressure 8 bar).
-
1 corrugated tube for connection to the dust extraction line.
Only authorised and specialised personnel may perform the arm installation operations.
