Runco Reflection RS-440, User Manual

Page: 65 / 84

Operation
Runco RS-440 Installation/Operation Manual 51
PRE
L
IMINAR
Y
Setup To adjust the lamp and perform other common, installation-related tasks, use the up- or
down-arrow buttons to highlight Setup in the Main Menu and press
ENTER .
Lamp Power: Select Lamp Power from the Setup Menu to adjust the lamp output level.
You can choose to run the lamp as bright as possible (230W; this is the default setting) or
you can choose the lower (180W) setting. Generally, lower lamp output prolongs the life of
the lamp, but decreases brightness.
Lamp Re s et: When you replace the projector lamp (refer to Lamp Replacement on
page 58), you should also reset the lamp timer. To do this, select Lamp Reset from the
Setup menu. The RS-440 shows the number of hours the projector lamp has been in
service and asks you to confirm or cancel the reset. Press
ENTER to confirm or EXIT to
cancel.
S ync Thre s hold: The projector is compatible with EDTV (480p and 576p) and HDTV
(720p, 1080i and 1080p) video signals. If a DVD player or other source component is not
syncing properly with the projector due to non-standard sync levels, adjust this setting to
correct the issue. This setting is only available for component video sources.
S ource S elect: The RS-440 can automatically detect an incoming signal and switch to
that input if the current source signal becomes unavailable. To enable automatic source
detection, choose Source Select from the Setup menu and set it to
Auto .
Film Mode: Use the Film Mode control to smooth out moving images from interlaced
sources. In most cases, the RS-440 detects the proper “pull-down” rate and vertical
frequency.
• Choose Auto to allow the deinterlacer to automatically determine the proper
deinterlacer mode for best display.
• Choose Off to force the deinterlacer to ignore film cadence and remain in video mode.
Use this setting if “combing” is present or if the deinterlacer switches between modes
constantly due to improper detection of film content (which can occur in animation, for
instance).
Digital Noi s e Reduction (DNR): Select DNR from the Setup menu, then use the
or button to adjust the amount of adaptive noise reduction. DNR is useful for
clearing up noisy images from interlaced SD sources. Adjust as desired, keeping in mind
that reducing noise (which reduces high frequencies) may also soften the image.
Background Color: Press the or button to select the image Background Color
(black or blue). The Background Color appears when no incoming signal is present.
12V Trigger: Select 12V Trigger from the Setup menu to configure the 12-volt trigger
output.
• Set the 12V Trigger to Normal if you want the trigger to activate when the projector is
turned on (for instance, if the trigger is controlling a retractable screen).
• Set the 12V Trigger to Cinema if you want the trigger to activate when the Cinema or
Virtual Cinema aspect ratio is selected.
S etup
Lamp Power 230 W
Lamp Re s et
S ync Thre s hold 1
S ource S elect Manual
Film Mode Auto
DNR 0
Background Color Black
12V Trigger Normal
Factory Re s et
Reset the Lamp Timer ONLY after you replace the lamp. Otherwise,
the reported “Lamp Hours” will be inaccurate.
Do not exceed the recommended lamp life of 2000 hours. An old
lamp becomes increasingly fragile and prone to sudden failure.
Note
WARNING