Runco Reflection CL-810 / SDC-1, Owner'S Operating Manual

Page: 45 / 92

Installation
Runco CL-810 Series Owner’s Operating Manual 33
PRE
L
IMINAR
Y
3.8
Changing the OSD
Language The CL-810 OSD language is initially set to English, but can also display the menus in
French, Spanish, Italian or German. To change the OSD language:
1. Press MENU .
2. Select Installation from the Main Menu and press ENTER .
3. Select Language from the Installation Menu and press ENTER .
4. Press or to highlight the desired language. (The change takes effect
immediately.)
3.9
Adjusting the Picture
Orientation By default, the CL-810 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. Press MENU on the remote control.
2. Select Installation from the Main Menu and press ENTER .
3. Select Picture Orientation from the Installation Menu and press ENTER .
4. Choose Floor Rear, Ceiling Front or Ceiling Rear to match the installation method.
3.10
Primary Lens
Adjustments The CL-810 gives you a great deal of control over the picture
size, position and focus. To access the motorized lens
controls, use the
FOCU S , ZOOM and LEN S buttons on the
remote control.
Focus To focus the projected image, press the FOCU S button, then use the left- and right-arrow
buttons to adjust the focus.
Zoom To make the picture smaller (zoom out), press the ZOOM button, then use the left-arrow
( ) button.
To enlarge the picture (zoom in), press the ZOOM button, then use the right-arrow ( )
button.
Vertical and Horizontal
Lens Shift Vertical Len s S hift: To shift the projected image vertically, press the LEN S button, then
use the up and/or down-arrow ( , ) buttons.
Horizontal Len s S hift (CL-810 Ultra Only): To shift the projected image horizontally,
press the LEN S button, then use the right and/or left-arrow buttons.
FOCUS LENS ZOOM
FOCUS ZOOM LENS