Controls and Functions
6
Runco CL-810 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
6.
POWER/
S
TANDBY LED
Indicates power status as follows:
• Orange when the projector is in standby mode
• Flashes orange for 45 seconds after the projector is turned on to indicate that the
lamp is warming up
• Green during normal operation
• Flashes green for 110 seconds after the projector is turned off to indicate that the
lamp is cooling down
7.
LAMP LED
Indicates lamp status as follows:
• Off during normal operation
• Red when the lamp has exceeded its usage life or developed a problem.
• Flashes red when the fans are not working or the lamp cover is open
8.
EXHAU
S
T VENT
9.
FRONT IR
S
EN
S
OR
Figure 2-2. CL-810 Rear/Bottom/
S
ide View
1.
RUNCO LO
G
O
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
2.
CABLE OPENIN
G
Pass cables through this opening.
3.
CABLE ACCE
SS
DOOR
Open to access connectors.
5
6
5
4
3
2
1
Summary of Contents for Reflection CL-810 / SDC-1
